Monday, March 5, 2012

Hole Callouts with Mechanical Power Tools (MPT)

“Mechanical Power Tools is a tooling add-on software package which includes a parametric parts library of nuts, bolts, holes, fasteners, etc., along with datum dimensioning, hole charting, block management, mechanical utilities, plot stamping, and more.” CADfx

Every one of the things mentioned above has been made easier to create and edit with the use of MPT, including hole callouts.

But before you begin placing callouts, you need holes!

Not just any holes though. Holes that were created with MPT and were created as blocks or as groups. So before you start dropping holes on your drawing, make sure you have selected one of the options under ‘Entity Mode’ - Group or Block.

CADFX-HOLES

Then go create some holes…

image

…and use the MPT Enhanced Leader to callout each hole.

The Enhanced Leader tool is found in the MPT menu pull down or in the MPT toolbar.

image

With the Enhanced Leader command active, pick a point on the hole were you want the callout leader to start.

image

The next screen pick will determine the end of the leader and location of the note. Click to place the note and press [ENTER] or right-click.

MPT will recognize the type of hole you selected and display an editor with the appropriate hole callout already selected. The only thing left for you to do is enter additional information regarding the hole count and depth.

At first glance, the editor text looks like gibberish. That text is actually a combination of our standard note, MPT hole calculation, and AutoCAD code for GD&T symbols. You’ll also notice highlighted field in the text. Those highlighted areas are where you are allowed to enter text. DO NOT CHANGE ANYTHING ELSE IN THE EDITOR.

The first highlighted area of the note is the quantity. Key in the required number of holes and press [TAB].

MPT-HOLE-NOTE-QTY

When you press [TAB] the cursor will highlight the next required field. This is usually the depth of a hole.

MPT-HOLE-NOTE-DEPTH

The default for these notes usually includes a depth. If your hole goes through the part, leave this value alone and edit the note with the MTEXT editor after you’ve finished creating it.

Keep pressing [TAB] and keying in information until there are no more blue fields and the ‘OK’ button is highlighted.

When you click ‘OK’, MPT will create your note and finish the callout.

image

What you have when you’re done is a properly formatted MTEXT note with an attached leader. This note can be edited like any other MTEXT note.

There are a few things to remember when using this tool.

  • You MUST be using MPT to create your holes. The tool isn’t designed to recognize hole created any other way.
  • You MUST create the MPT hole as a Block or Group.
  • You MUST not alter the MPT hole. If you place the wrong hole, change it with MPT Power Swap or Power Edit.
  • Only edit the highlighted areas of the note in the note editor. Do not change any other text.

That’s it! All you need to know about creating hole callouts with MPT.

No comments:

Post a Comment